Table of Contents
Advertisement
3. GETTING STARTED
3.1 RADIO CARE
Before following the instructions below, insure the battery pack is in place
and firmly connected. Care must be taken if the radio was dropped and
a close inspection may be needed to insure the radio case and gaskets
are in adequate condition.
The design of the HX407 allows water to enter between the radio and the
battery pack, however waterproof performance is not compromised.
After using the HX407 in salt water environment is recommended to clean
the radio with fresh water by rinsing the battery and radio (separately) under
a sink facet or by dunking in a fresh water. After washing,use a soft cloth to
thoroughly dry all parts of the radio and battery.
This will keep the radio parts and the battery clean and in top operating con-
dition.
3.2 BELT CLIP INSTALLATION AND REMOVAL
To install the Belt Clip: align the
Belt Clip to the groove of the Bat-
tery pack, then press the Belt Clip
downward until it locks in place
with a "Click."
Page 6
CAUTION
To remove the Belt Clip: press the
Belt Clip Tab away from the bat-
tery pack to unlock the Belt Clip,
then slide the Belt Clip upward to
remove it.
Belt Clip Tab
Application for FCC / IC
FCC ID: K6630394X20
IC: 511B-30394X20
HX407
Advertisement
Table of Contents
