Setting Up Routing Directory - Standard Horizon HX890E Owner's Manual

11.2.1 Setting Up Routing Directory

All the destinations and via-points must be programmed as waypoints
in the HX890 memory. Refer to section "11.1.2 Setting Up Waypoint
Directory".
Adding a Route
Press and hold

key
1. Select "ADD" with the [CH▼]/[CH▲] key,
then press the [SELECT] soft key.
2. Select "NAME" with the [CH▼]/[CH▲] key,
then press the [SELECT] soft key.
3. Enter a name for the route by pressing the
[CH▼]/[CH▲] key and the [SELECT] soft
key.
When the name entry is complete, press the
[FINISH] soft key.
4. Select "ROUTE" with the [CH▼]/[CH▲] key,
press the [SELECT] soft key.
5. Select "WPT:" with the [CH▼]/[CH▲] key,
then press the [SELECT] soft key.
6. Press the [CH▼]/[CH▲] key to select a
waypoint, then press the [SELECT] soft key.
7. Select "Via1:" with the [CH▼]/[CH▲] key,
then press the [SELECT] soft key.
8. Press the [CH▼]/[CH▲] key to select a
waypoint, then press the [SELECT] soft key.
9. Repeat steps 7 and 8 to add more "Via..."
waypoints.
10. Press the [BACK] soft key.
11. Select "SAVE" with the [CH▼]/[CH▲] key,
then press the [SELECT] soft key to store
the route into memory.
12. Press the [CLR] key to return to radio operation.
68
WAYPOINT SETUP

( / key)
NOTE
SELECT
ROUTE DIR.

(
( key)
WAYPOINT SETUP
BACK
NAME:
001RUT----------
BACK
YAESU
366901254
BOB
Horizon-1
Horizon-2
KAREN
Standard
USCG
BACK
NAME:
001RUT----------
BACK

/ key)
ROUTE DIR.
ADD
EDIT
DELETE
ROUTE DIR.
NAME:
001RTE----------
SELECT
BACK
ROUTE DIR.
ROUTE
SAVE
001RUT __________
WPT:
Via1:
SELECT ROUTE DIR.
DISPLAY RANGE
ARRIVED RANGE
ROUTE DIR.
ROUTING OPERATION
BACK
001RUT __________
WPT:KAREN
Via1:
ROUTE DIR.
SELECT
DISPLAY RANGE
ARRIVED RANGE
ROUTE DIR.
ROUTING OPERATION
BACK
ROUTE
SAVE
SELECT
SELECT
( key)
ROUTE
SAVE
SELECT
SELECT
SELECT