Belt Clip Installation / Removal - Standard Horizon HX100 Owner's Manual

 The PA-48B is only designed for the charging of the HX100/HX150's
battery packs, and is not suitable for other purposes. The PA-48B
may contribute noise to TV and radio reception in the immediate
vicinity, so it do not recommend its use adjacent to such device.
 When carefully maintained, a pack should be useful for about 300
charge/discharge cycles.

4.3 BELT CLIP INSTALLATION / REMOVAL

 To install the Belt Clip: align the
Belt Clip to the groove above the
Battery compartment, then press
the Belt Clip downward until it
locks in place with a "Click".
Page 16
NOTE
ê
 To remove the Belt Clip: press
the Belt Clip tab away from the
transceiver to unlock the Belt
Clip, then slide the Belt Clip up-
ward to remove it.
Belt Clip Tab
é
HX100/HX150