Installation; Safety During Installation - RAYLASE SUPERSCAN IV-10 Manual

4 INSTALLATION

4 INSTALLATION
Installation may only be carried out by trained personnel. These trained personnel must be familiar
with the general safety regulations that are applicable for installation and operation of opto-
mechatronic systems, machines, and plant.
4.1

Safety during installation

Hazard due to electrical energy
The deflection unit is designed for operation with a safe extra-low voltage supply (< 60 V DC). The
operator is responsible for safety of the power supply (voltage limitation, shutdown on overcurrent,
line protection).
 Make sure that the power supply does not exceed the specified low voltage.
 During all work on the electrical power supply and the electrical systems, observe the relevant
electrical safety regulations.
Risk of injury due to laser radiation
The laser beam (including a reflected beam) can cause severe injuries to the eyes and skin.
The laser system may only be installed and started up by trained personnel.

 Before carrying out any work, make sure that the laser equipment is switched off and secured
against being switched on again.
 After all work, make sure that all housing covers are in place.
Risk of injury due to falling product
A falling product unit can cause injuries.
 The product should be installed by two people wearing suitable safety shoes.
 In case the product fell down it must not be used any more. It has to be sent back to RAYLASE
for service.
© 2022 RAYLASE GmbH SUPERSCAN IV
WARNING
C 3-0 10. 1
WARNING
C2 -01 0
WARNING
C2 -03 0
MN105-en / v1.0.12 32