Changing The Main Fuse - Husqvarna FC 350 2020 Owner's Manual

14 ELECTRICAL SYSTEM
14.4
110

Changing the main fuse

Warning
Fire hazard Incorrect fuses overload the electrical system.
–
Only use fuses with the required ampere value.
–
Do not bypass or repair fuses.
Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
–
Allow the voltage regulator to cool down before performing any work.
Info
The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing
under the seat.
S02323-10
These battery chargers test whether the 12 V bat-
tery retains its voltage. It is also impossible to over-
charge the 12 V battery with these battery chargers.
The charging time may be longer at low temperatures.
These battery chargers are only suitable for lithium
iron phosphate batteries. Read the accompanying
instructions for Husqvarna Motorcycles accessories.
Info
Never remove cover
–
Switch off the battery charger after charging and disconnect
from the 12 V battery.
Finishing work
–
Install the 12 V battery.
–
Mount the seat. ( p. 63)
–
Install the air filter box cover. (
Preparatory work
–
Press and hold the kill switch
the engine stops.
–
Remove the air filter box cover. (
–
Remove the seat. ( p. 63)
Main work
–
1
Pull starter relay from the holder.
1
.
( p. 108)
p. 64)
while the engine is idling until
p. 64)