Shure Microflex MXW Manual page 94

Analog Connections
Outputs
Configuration
Active Balanced
Input(s)
Configuration
Active Balanced
Headphone Output
6.35 mm (1/4") TRS, 100 mW, 350 Ω, dual mono (will drive stereo phones)
0 dBV = 1 V RMS; 0 dBu = 0.775 V RMS; 0 dBV = 2.2 dBu
Digital Signal Processing
AD/DA Converter
24­bit, 48 kHz
Latency
Estimated Nominal, ±0.1 ms
Analog-to-Dante
Dante-to-Analog
T = Network latency in milliseconds, as set in Dante Controller.
N
Note: Dante network latency is typically associated with the receiving device.
Networking
Network Interface
Four-Port Gigabit Ethernet Switch, Dante digital audio
Uplink Port (Port 4)
Selectable, blocks multicast traffic
Power over Ethernet (PoE)
Provided on Port 1 to power MXWAPT
Cable Requirements
Cat 5e or higher, shielded, 100 m maximum between network devices
Network Addressing Capability
DHCP, link-local, static
Clipping Level (minimum)
Impedance
Line
310 Ω +26.2 dBV
Impedance
10.6 kΩ
Aux
+16.2 dBV
Clipping Level (minimum)
Line
+23.8 dBV
0.21 ms
0.24 ms + TN
Shure Incorporated
Mic
−3.8 dBV
Aux
+10.8 dBV
94/100