Table of Contents
Advertisement
Back Panel
① AC Power
IEC connector 100 - 240 V AC.
② Power Switch
Powers the unit on or off.
③ Output Block Connectors (1-8)
Three-pin, low-voltage differential connector provides a line-, aux- or mic-level analog output for each channel.
④ Chassis Ground (1-8)
Use to directly ground the cable shield to the chassis.
⑤ Input Block Connectors (A,B)
Three-pin, low-voltage differential input connector adds line- or aux-level analog signals to the digital network.
Note: This input is meant for balanced connection. If an unbalanced source is used, such as an IPOD or MP3 player, only use pins 1 (signal) and 3 (ground) of
the block connector. See Specifications sections for wiring diagrams.
⑥ Reset Button
Press and hold the button for five seconds to reboot the device with factory default settings.
⑦ Ethernet Status LED (Green)
◦
Off = no network link
◦
On = network link established
◦
Flashing = network link active
⑧ Ethernet Link Speed LED (Amber)
◦
Off = 10/100 Mbps
◦
On = 1 Gbps (required for digital audio routing)
⑨ Network Interface
Four-port gigabit switch for connecting components together for a single MXW Group, or for connecting multiple devices to
a larger digital audio network. The following is a description of each port:
Port
Description
Provides Power over Ethernet (PoE) for the Shure access point and functions as a standard gigabit
Port 1 (PoE)
port.
Shure Incorporated
12/100
Advertisement
Table of Contents
