Table of Contents
Advertisement
Requirements
The MXW system must be operating on a minimum firmware version of 8.0.3.
Set Up
1.
Open the desired MXWAPT by double-clicking from the Devices view.
2.
Go to the Utility page.
3.
Open the Device Properties window for the two- or four-channel access point (MXWAPT2 or MXWAPT4).
4.
Note that the APT is set to Mode A by default (Device View > RF Mode Settings > RF Coordination Mode). Close
out of the window.
5.
Open the Device Properties for the adjacent APT2 or APT4.
Alternate Antenna Modes to use the Full Spectrum
Shure Incorporated
56/100
Advertisement
Table of Contents
