Shure Microflex MXW Manual page 42

1. Go to the Configuration
Tab
2. Select the Access Point
Transceiver (APT) for
Group 1
3. Select the Network
Charging Station(s)
4. Select the Audio Output
Device(s)
Note: Component group and microphone link data are persistently stored in each device. If the MXW system is shut off and then restarted without a computer,
the devices will remain associated to the access point.
Device Availability
When setting up a group or managing devices, it is important to understand the difference between open and associated de­
vices.
Assign the devices to groups from the Configuration tab of the MXW control software.
Select an APT to determine group channel count (2, 4 or 8).
Group 1 automatically uses the APT opened from the Devices list. Other networked (and open) APTs are available
for additional groups.
Select one or two Network Charging Station (NCS) to the access point. An additional charg­
er can be added to the group:
• When using multiple smaller chargers to fill the channel count of the group. For exam­
ple, two 4-channel chargers for an 8-channel group.
• When using gooseneck microphones. Gooseneck mics cover the front and back slots of
a charger, halving the number of slots available. For example, two eight­channel charg­
ers are required to fill an eight-channel access point with gooseneck microphones.
Select one or two audio output devices (MXWANI or SCM820) to automatically route the dig­
ital audio channels from the access point. Select from the following devices:
• Audio Network Interface (MXWANI) four- or eight-channel variation.
• Shure SCM820 IntelliMix Mixer. Dante-enabled SCM820s can be selected as the audio
output for the Group. This automatically routes the SCM820's aux input to the micro­
phones for personal monitoring (SCM820 aux left channel to MXW channels 1 - 4; aux
right channel to MXW channels 5 - 8).
®
Shure Incorporated
42/100