Table of Contents
Advertisement
Color
Status
One or more connected receive channels experiencing a subscription error or is unresolved (trans
mitting device is off, disconnected, renamed or has incorrect network setting).
Receiving an Identification signal from the control software (simultaneous flash with Link Status
Flashing Green
LED).
The device is performing a spectrum scan (alternating flash with Link Status LED).
Clock synchronization problem.
Off
No receive channels connected (routing has not been established).
Note: the network audio status can be monitored in detail from Dante Controller software.
③ Microphone Link Status LED
Color
Green
Off
Red
Flashing Red
④ Reset Button
Press and hold the reset button for 10 seconds to reset the MXW system to factory default settings.
Note: The reset deletes group association and microphone links, and will reboot the device in DHCP mode.
⑤ Ethernet Port
Connect a shielded Cat5e (or higher) cable to a PoE source and the network.
⑥ Ethernet Status LED (Green)
◦
Off = no network link
◦
On = network link established
◦
Flashing = network link active
⑦ Ethernet Link Speed LED (Amber)
◦
Off = 10/100 Mbps
◦
On = 1 Gbps (required for proper MXW functionality)
⑧ Cable Routing Path
Provides a path for the Ethernet cable to enable a flush-mount to the ceiling or wall.
Status
≥1 microphone is linked and powered on in the Active, Mute or Standby state.
≥1 microphone is linked and is Off or in a nonnetworked charger.
No microphones have been linked.
Receiving an Identification signal from the control software (simultaneous flash with Network
Audio LED).
The device is performing a spectrum scan (alternating flash with Network Audio LED).
Shure Incorporated
14/100
Advertisement
Table of Contents
