Table of Contents
Advertisement
② Density Mode Selection
Displays the density mode as selected in the APT device properties.
③ Spectrum Scanner
Opens the Spectrum Scanner window. See Scanning Available RF Spectrum section for more details.
④ Global Mic Control
Controls the status of all microphones in the configuration (all groups made from the Configuration tab).
⑤ Channel Name
Channel names are customizable for channel (RF and Audio) identification. The name is associated with the channel on the
APT, will be stored on it, and is independent from the microphone linked to that channel.
⑥ Device Name
Device names are customizable for microphone identification. The name is associated with the registered microphone, will
remain stored on it, and is independent from the channel it is linked to.
⑦ Microphone Link Slot
Selects the which microphone displays on the channel strip.
Note: One microphone is on-air per channel, though an alternate microphone can be prepared in the secondary link slot.
⑧ Microphone Status and Control
View or change the microphone state:
◦
Active: On and passing audio to the network.
◦
Mute: On but the audio is muted.
◦
External: On and passing audio to an external controller that controls the mute/active behavior.
◦
Standby: On but in a 'sleep' state with audio muted. Standby conserves battery charge and enables a change to the
microphone's status from the control software.
◦
Charging: Battery is charging.
◦
Inactive: Off or out-of-range. A microphone in this state cannot be remotely controlled by the software.
◦
Power Off: Turn off the microphone.
⑨ Battery Status
◦
In the charger: Displays the remaining time until the microphone battery is fully charged
◦
Out of the charger: Displays the remaining battery runtime of the microphone.
⑩ Audio Input Meter
Indicates the average input signal level.
Color
Red
Yellow
Green
Audio Signal Level (dBFS)
0 to -9
-9 to -18
-18 to -60
Description
Overload
Normal peaks
Signal Present
Shure Incorporated
67/100
Advertisement
Table of Contents
