Table of Contents
Advertisement
T O R Q U E S E T T I N G S
IN ORDER TO MAINTAIN THE IP65 RATING ON THE LIGHTING FIXTURES, ALL SCREWS MUST
BE TIGHTENED TO THE FOLLOWING TORQUE SPECIFICATION USING A TORQUE DRIVER.
These screws must be torqued to 11.3 lb-in (13.0 kg-cm).
TORQUE DRIVERS (Recommended): UTICA TS-30 (shown)
ALTERNATE DRIVERS:
• Proto J6107A
• Wiha 28887
CAUTION! DO NOT OVER TORQUE SCREWS AS THIS CAN CAUSE LEAKAGE
ISSUES! TO CONFIRM THE IP65 INTEGRITY AFTER A LAMP REPLACEMENT,
TEST THE FIXTURE USING THE ELATION IP TESTER. CONTACT ELATION
SERVICE FOR MORE DETAILS.
CAUTION! THE USE OF PROTECTIVE GLOVES AND SAFETY GOGGLES IS
STRONGLY RECOMMENDED WHILE PERFORMING THE IP PRESSURE TEST!
AVOID PLACING YOUR FACE, EYES, HANDS, ETC IN CLOSE PROXIMITY TO
THE FIXTURE'S LENS WHILE PERFORMING THE TEST!
Low Pressure Limit
1.65 psi (11.4 KPa)
IP PRESSURE TESTING PARAMETERS
High Pressure Limit
1.70 psi (11.7 KPa)
43
Steady/Hold Time
3 sec
Advertisement
Table of Contents
