Electrical Connections - Borger STE-RSM2 Operating Manual

Transportation, As-delivered Condition, Storage, Installation
4.4.3

Electrical connections

BA-STE-RS, 26.09.2014
Danger!
Risk of fatal injury due to electric shock!
Electrical connections may only be installed by qualified
electricians.
Please observe
— the instructions and safety regulations set out in the
installation instructions and operating manuals of the
manufacturer of electronic components, and
— the circuit diagram provided in the appendix.
Notice
Risk of material damage in the event of incorrectly
connected electrical connections!
The equipment will not function properly if the electrical
connections have been connected incorrectly. Severe material
damage to the components may result, e.g. due to an incorrect
direction of rotation with connected Multicrushers or Rotorrakes.
Note
Multicrushers and Rotorrakes are designed for a fixed
direction of rotation in line with the flow direction according
to the order. These units must not be operated in the other
direction of rotation without conversion, except during the short
reversing process.
By default, the control unit as well as the enclosed circuit
diagram are designed for clockwise operation of the motor.
If your Multicrusher / Rotorrake was designed for counter-
clockwise operation, the phase conductor which, according
to the circuit diagram, must be connected to outlet U, is to
be connected to V and vice versa.
www.boerger.de / www.boerger.com 45