Safety Instructions For Operating Personnel - Borger STE-RSM2 Operating Manual

Safety
2.7

Safety instructions for operating personnel

BA-STE-RS, 26.09.2014
The control unit and the components controlled by it may only be
operated while they are fully assembled, in perfect working
condition and only for their intended purpose, in a safe and risk-
conscious manner having regard to this operating manual.
All malfunctions must be rectified immediately and professionally,
especially those affecting safety. This applies particularly to
defects such as loose electrical connections, frayed, burnt, kinked
or otherwise damaged cables etc.
Every person assigned with commissioning, operation or
maintenance work must have fully read and understood this
operating manual beforehand – specifically chapter 2, Safety.
Consulting the manual during work is already too late. This
applies especially to personnel that only work occasionally on the
control unit.
The operating manual must always be kept accessible next to the
control unit.
No liability will be assumed for any damage and accidents caused
by non-compliance with the operating manual.
Adhere to the applicable accident prevention regulations and all
other generally recognized safety regulations and guidelines for
occupational health at work.
Clearly specify the responsible parties for the various
maintenance and repair tasks and adhere thereto. Only then can
handling errors be avoided, especially in dangerous situations.
If the control unit or the connected components malfunction:
●
Use the emergency stop switch to shut down the control unit
and the connected components immediately.
●
Turn the main switch to OFF.
●
Ensure that the control unit cannot be switched on again, e.g.
by locking the main switch with a U-lock.
●
Take all necessary measures in order to shut down the
connected devices (e.g. close the valves).
●
Report the malfunction to the responsible department/person.
www.boerger.de / www.boerger.com 17