Lbb 3511/00 Dip-Switch S12 And S13 Settings - Bosch Digital Congress Network Installation And Operating Manual

Digital Congress Network | Installation and Operating Manual | Chapter 5 - Control using PC

5.4.2 LBB 3511/00 DIP-switch S12 and S13 settings

For location details see FIG 5-5
DIP-switch S12 : Assign cards digital input (0 - 31)
DIP-switch S13 : Assign cards 1/O (Input/Output) address (04E0 HEX)
DIP-switch S12
IP switches to define the card's 'digital input'.
Table 5-2: DIP-switch S12
LBB 3511/00 PC-card for Multi-CCU systems
SW 1 ON Chairman priority tone ON (default)
OFF Chairman priority tone OFF
SW 2 OFF Reserved for card's Master Address (IMPORTANT: must NOT be changed)
SW 3 OFF Reserved for card's Master Address (IMPORTANT: must NOT be changed)
SW 4 OFF Reserved for card's Master Address (IMPORTANT: must NOT be changed)
SW 5 OFF Reserved for card's Master Address (IMPORTANT: must NOT be changed)
SW 6 ON Active microphones and requests will be permanently switched OFF if the
priority function of the chairman's unit is activated.
OFF Active microphones will be switched OFF temporarily if the priority
function of the chairman's unit is activated (default)
SW 7 OFF Reserved for card's Master Address (IMPORTANT: must NOT be changed)
SW 8 OFF Reserved for card's Master Address (IMPORTANT: must NOT be changed)
8 7 6 5 4 3 2 1
S12
ON
Bosch Security Systems | 04-2003 | 3922 988 43318 en
DIP-switch S13
Table 5-3: DIP-switch S13
IMPORTANT:
DO NOT CHANGE
Get other manuals https://www.bkmanuals.com
LBB 3511/00 PC-card for Multi-CCU systems
DIP-switches to define the cards I/O address (default: 0200 HEX)
I/O address 0100 HEX 0140 HEX
SW 1 OFF OFF
SW 2 OFF OFF
SW 3 ON ON
SW 4 OFF OFF
SW 5 OFF ON
SW 6 OFF OFF
SW 7 OFF OFF
SW 8 OFF OFF
Actual address settings DIP switch S13
Address (0100HEX) Address (0140HEX)
8 7 6 5 4 3 2 1
8 7 6 5 4 3 2 1
S13 ON S13
DIP-SWITCH S13 DIP-SWITCH S13
Address (0280HEX)
Address (0200HEX) (default)
8 7 6 5 4 3 2 1 8 7 6 5 4 3 2 1
S13 S13
ON
DIP-SWITCH S13
DIP-SWITCH S13
NOTES:
1. Available addresses (HEX): 0100, 0140, 0200 (default), 0280.
These addresses must be set with the DIP-switches and in the Config.sys file of the OS/2
PC.
2. Available interrupts IRQ: 3, 4, 5, 7, 9, 10 (default) and 12.
NOTE: These interrupts must be set in the Config.sys file of the OS/2 PC.
en | 5-5
0200 HEX 0280 HEX
OFF OFF
ON ON
OFF OFF
OFF ON
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ON
ON
LBB 3511/00 PC Card for Multi-CCU Systems
2