Operating The Interpreter Desk; Incoming Channel Selection; Assigning Pre-Select Keys; Incoming Floor Switch And Auto-Relay - Bosch Digital Congress Network Installation And Operating Manual

Digital Congress Network | Installation and Operating Manual | Chapter 11 - System Set-up and Operation
Floor
1
A A
Japanese French
FIG 11-9 Normal operation (floor active)
Floor
4
B
A
English
Japanese French
FIG 11-10 Relay Interpretation (Auto-relay active)
Bosch Security Systems | 04-2003 | 3922 988 43318 en
ENGLISH
English
Floor
2 3 4
A A
German English
JAPANESE
Floor
Auto-relay
2 3 4
A A
German English
Get other manuals https://www.bkmanuals.com

11.10 Operating the Interpreter Desk

11.10.1 Incoming Channel Selection

Using the desks three Incoming channel pre-select keys,
one of three familiar incoming languages for translations. The diagram below shows the three pre-
select keys with their LED indicators.
Incoming Channel personal pre-select keys a, b and c

11.10.2 Assigning Pre-select keys

Refer to interpreter desk overlay.
a b c
1. Select one of the keys , or that is to be assigned to an incoming language channel.
2. When the assigned key has been pressed and its associated LED is lit, turn the incoming channel
selector knob 'Relay select' to the left or right to visually scan and select the required incoming
language. The last language selected will be assigned to the selected pre-select key.
3. The above procedure is used to assign the remaining two pre-select keys.

11.10.3 Incoming Floor switch and Auto-relay

1. Pressing the Incoming floor key, switches the incoming language channel to the floor channel or to
the Auto-relay channel, if Auto-relay has been programmed. This action illuminates the LED
marked 'Floor', or if applicable the LED marked 'Auto-relay'.

11.10.4 Language Quality Indication

The language quality indication gives the interpreter an at-a-glance quality of the incoming language.
For example, FLOOR above an incoming language indicates that, that language is the original floor
+
language. A plus sign ( ) displayed above an incoming language, indicates that the translation is based
on a direct translation of the original floor language. A minus sign (
language indicates that the translation is an indirect translation and based on the translation of another
translation derived from the original floor language.
en | 11-17
a b c
, and , the interpreter can quickly select,
-
) displayed above an incoming
Operating the Interpreter Desk
2