Entering The Desks Programming Mode; Menu Programming Procedures - Bosch Digital Congress Network Installation And Operating Manual

Digital Congress Network | Installation and Operating Manual | Chapter 11 - System Set-up and Operation

11.11.2 Entering the desks programming mode

Before attempting to program the interpreter desk, ensure that the system has first been initialized
Initializing). If the system has been initialized and the display shows 'DESK NOT
(see Chapter 11.1
INSTALLED' ,the desk is ready to be programmed.
* * * * * * * DESK NOT INSTALLED * * * * * * *
NOTE:
Only one desk can be programmed at the same time.
Programming
To enter the desk in to its "
Pre-select b
1. Press the key ' ' and the '
The Installation mode is shown as follows:
Installation mode, press 'Floor' to
enter or 'Mute' to clear, use 'Select'
knob to select option and B - select '<>'
keys to select next or previous function
NOTE:
Due to the length of the opening message, the message is displayed over additional
screens. The message in full is as follows:
Installation mode, press 'Floor' to enter or
'Mute' to clear, use 'Relay select' knob to
select option and B-select '<>' keys to
select next or previous function.
Bosch Security Systems | 04-2003 | 3922 988 43318 en
" mode proceed as follows::
Outgoing B
' keys simultaneously.
Get other manuals https://www.bkmanuals.com

11.11.3 Menu Programming procedures

B-Select
STEP 1.
Press the ' ' up/down keys < > to scroll through and select the required
Installation menu.
STEP 2.
Once in the chosen menu, rotate the '
light the required selection. Arrow brackets <..> highlight the chosen entry. If this
function is not available, press the '
A previous setting is displayed with square brackets [..].
STEP 3.
To input and confirm the selected entry, press the '
selected entry is surrounded with square brackets [..].
STEP 4. Mute
Press the ' ' key to clear a previous settings. Pressing this key throughout the
programming mode allows a previous settings to be cleared, ready for new input data
and errors to be corrected.
en | 11-21
Relay select
' knob (left, up, right, down) to high-
Mute
' key to clear a previous setting.
Floor
' key. Once entered, the
Programming the Interpreter desk
2