Table of Contents
Advertisement
Protect hooks, wire ropes, chains and brakes against corrosion.
4
Description
4.1
Areas of application
The devices must be as far as possible installed in a covered room.
If they are used in the open, protect the units against the effects of weather such as rain, hail, snow, direct
sunshine, dust, etc. - we recommend to use a cover in parking position. If the device is set up in a
continuously humid environment with strong temperature fluctuations, the correct functionings are
endangered by the forming of condensation.
NOTICE!
Use only in the intended atmosphere with a humidity of up to 100%, but not under water!
DANGER!
It is not permitted to use the unit in an area at risk from explosion!
4.2
Design
The wirerope winches for stationary use are fitted with holes for installation.
The winch handle is detachable.
The winch can be installed in any position desired, make sure, however, the wire rope exit is correct.
For outside use we recommend to use a protective roof.
Versions:
Type 238/10
Standard
*as option
4.3
Functions
The load is lifted/ lowered, by turning the winch handle. The incorporated load-pressure-brake prevents
automatic lowering of the load after release of the winch handle. Little after run of the load or turn of the
winch handle is due to the system and not a mistake.
4.4
Important components
Housing
238/10
- made in steel plate
238/10GV
- made in steel plate - galvanized
238/10MV
- made in steel plate - special coating
5.52.208.00.01.07
Type 238/10
with separating
partition and two rope
exits*
Type 238/10GV
galvanized version
Type r 238/10MV
Marine-version
7
Advertisement
Table of Contents
