Table of Contents
Advertisement
DANGER!
In case of incorrect winding direction, the load pressure brake is not working.
6.4
Winding up of wire rope
The wire rope must always be winded up tensioned. When the last wire rope layer is winded onto the drum,
the flanged wheel must exceed the top layer by at least 1 1/2 times of the wire rope diameter.
NOTICE!
According to validated regulations and accident prevention regulations, the wire rope length must be
chosen so that at least 2 rope layers remain on the drum when the wire rope is unwinded.
6.5
Wire rope deflection
Wire rope pulleys must be installed in a position centrically to
the rope drum.
In order to ensure correct winding up of the wire rope on the
drum, the max. wire rope deflection angle must not be
exceeded.
maximum wire rope deflection angle
4° for standard wire ropes
2° for non-twisting resp. twist-resistant wire ropes
The minimum dimension (M) from the drum until the middle of
the pulley must be adhered to.
6.6
Tools
Capacity
Size
250 – 1500 kg
SW19
2000 – 7500 kg
SW30
7
Control
Only people that are familiar with the operation of the lifting devices and cranes may be entrusted with their
operation. They must be authorized by the employer for the operation of the equipment. The employer must
ensure that the operating instructions are available near the equipment and that they are accessible for the
operating personnel.
Lifting and lowering by turning the hand crank.
Lifting load – turn clockwise.
Hold load – release hand crank. The load holds
automatically. Acc. The different types, the crank
can removed in each position or the crank grip
can fold back.
Lowering load – turn anti clockwise.
10
Tool
div.
div.
Illustration 4
Use
Winch fastening
Rope installation
5.52.208.00.01.07
Advertisement
Table of Contents
