HADEF 238/10MV Installation, Operating And Maintenance Instruction page 14

 Position of the broken threads
 Timing sequence of occurrence of breaks.
 Reduction of the wire rope diameter.
 Corrosion
 Abrasion
 Deformation
 Heat influence
 Operation time
 Wire rope fastening
CAUTION!
The wire rope must be replaced immediately should even one strand be broken.
13.2 Gear
quarterly: lubricate the worm gear wheel and the worm gear shaft
Recommended lubricant: grease, FUCHS Renolit FEP 2, or similar
13.3 Gear spring pressure brake
During the check, brake lining wear is verified. The brake linings must be replaced when the wear limit is
already reached at one position of the lining, - as this can be the case when wear of the linings is irregular.
CAUTION!
The brake linings must be free from fracture. Avoid oil, grease, dirt and humidity on the brake linings as this
increases wear.
13.4 Lubricant - Selection
FUCHS SHELL
Renolit FEP 2 Alvania EP 2
Stabylan 5006 --
-- --
Lubricant for food industry – Selection (as option*)
13.5
SHELL
Gearing
FM Grease HD2
Load chain
--
Load hook;
Pulleys
FM Grease HD2
Gear rim;
Drive pinion
* must be mentioned by order
14 Trouble
Please pay attention to the following in case of problems:
 Troubles with the equipment must only be repaired by qualified personnel.
 Secure the unit against unintended operation start.
 Put up a warning note indicating that the unit is not to be used.
 Secure the working area of moving parts of the unit.
 Please read the chapter "Safety instructions".
Notes on the repair of faults are found in the following table.
For the repair of failures please contact our service department.
14
ESSO MOBIL
Unirex EP 2 Mobilux EP 2
-- --
-- --
Chain lubricant OKS 451
MOBIL
Mobilgrease FM 222
Optimol Viscoleb 1500
Lubricant FM 100
Mobilgrease FM 222
TOTAL CASTROL
MULTIS EP2 --
-- Optimol Viscoleb 1500
-- --
KLÜBER
CASTROL
--
Klüberoil 4UH 1-1500 N
--
--
--
KLÜBER
--
Klüberoil 4UH 1-1500
Wolfracoat 99113
5.52.208.00.01.07