Transport And Storage; Transport; Safety Device For Transport; Storage - HADEF 260/23 Installation, Operating And Maintenance Instruction

Manual spur gear wire rope winch
Table of Contents

Advertisement

 Do not use a defective unit; listen for abnormal operating noises.
 In case of malfunctions, stop the operation immediately and rectify the fault.
 Report damage and defects immediately to a responsible person
 When working with the unit, warn persons in the immediate vicinity.
 Observe the provisions for load suspension equipment in accordance with the relevant national
regulations for the positive and non-positive slinging of loads.
 The sling or load must be securely attached to the load hook and rest on the bottom of the hook.
 The safety latches of hooks must be closed.
 The housing must not be in contact with anything.
 Motor drive is prohibited.
WARNING!
The following is not allowed:
 to lift another load than the nominal safe working load
 to manipulate the sliding clutch if units are equipped with
 The use of elongated or damaged chains or wire ropes. Replace them immediately by new, original
parts.
 Never loop the load chain around a load nor place or pull the chain over edges.
 Never repair damaged load hooks (e.g. by hammering), but replace them by original hooks.
3

Transport and Storage

CAUTION!
Transport may only be done by qualified personnel. No liability for any damage resulting from improper
transport or improper storage.
3.1

Transport

The devices are checked and if so adequately packed before delivery.
 Do not throw or drop the equipment.
 Use adequate means of transport.
Transport and means of transport must be suitable for the local conditions.
3.2

Safety device for transport

NOTICE!
Should a safety device for transport exist, please remove it before commissioning.
3.3

Storage

 Store the equipment at a clean and dry place.
 Protect the equipment against dirt, humidity and damage by an appropriate cover.
 Protect hooks, wire ropes, chains and brakes against corrosion.
DANGER!
Units that show corrosion must be taken out of service!
4

Description

4.1

Areas of application

The devices must be as far as possible installed in a covered room.
If they are used in the open, protect the units against the effects of weather such as rain, hail, snow, direct
sunshine, dust, etc. - we recommend to use a cover in parking position. If the device is set up in a
continuously humid environment with strong temperature fluctuations, the correct functionings are
endangered by the forming of condensation.
6
5.52.246.00.01.02

Advertisement

Table of Contents
loading

Table of Contents