Related Manuals for HADEF 190/94
Summary of Contents for HADEF 190/94
- Page 1 Installation,- Operating and Maintenance Instructions HADEF Stainless Steel Wire Rope Winch Type 190/94 + 192/98 with fast wirerope movement and disengag- Type 190/94 ing mechanism for the drum 5.52.248.00.01.02 Rev.02...
-
Page 2: Table Of Contents
Heinrich de Fries GmbH Heinrich de Fries GmbH, Gauss Str. 20, D-40235 Düsseldorf Heinrich De Fries GmbH will be named HADEF in the following text. Original operating- and maintenance instructions in German language. Translation in other languages is made of the German original. -
Page 3: Information
11.2 Monitoring ........................11 Inspection ..................11 12.1 Periodic checks ....................... 11 12.2 Wire rope .......................... 11 12.3 Inspection intervals ......................12 Service ....................12 13.1 Wire rope .......................... 12 13.2 Gearing ..........................12 13.3 Lubricant - Selection ....................... 12 13.4 ... -
Page 4: Duty Of Care Of The Owner
Failure to follow the instructions of this manual can lead to unpredictable hazards. For any resulting damage or personal injury, HADEF assumes no liability. The unit was designed and built following a risk analysis and careful selection of the harmonized standards that are to be complied with, as well as other technical specifications. -
Page 5: Appropriate Use
Appropriate use The permitted safe working load of the devices must not be exceeded! An exception can be made during the load test before initial operation, carried out by a licensed qualified person. The permissible ambient temperature during operation of manual driven devices is -20 ° C / + 50 ° C and at all power driven devices -20 °... -
Page 6: Transport And Storage
Please pay attention to the regulations for load carrying devices UVV for both positive and non-positive methods of attaching loads. The lifting tackle or the load must be securely attached to the hook and be seated at the bottom of the hook. -
Page 7: Design
It is not permitted to use the unit in an area at risk from explosion! Design HADEF wire rope winches for stationary use are fitted with holes for installation. The housing if made of stainless steel. The crank is detachable. -
Page 8: Technical Data
1st layer top layer tion with opera- load tion 190/94 1 Em 192/98 1 Em Installation Please observe the following points in order to avoid any damage to equipment or injury of person: Wear safety gloves. Install the winch on a stable ground. -
Page 9: Wirerope Fastening
Wirerope fastening There is a plate on the winch indicating the wind up direction. We recommend to solder the wirerope end thoroughly. Fastening the wirerope to the drum. When turning the crank clockwise, the wirerope must wind up onto the drum anti-clockwise. Fix the wirerope end to the rope drum by cramming it. -
Page 10: Commissioning
Only for Type 190/94 Moving with load (A) - operation fast moving operation (B) - by fixing the crank on the other crank pin (B) it is possible to increase the lifting range per crank turn NOTICE! In case of fast moving operation (B), the crank can only be turned anti-clockwise - the load can only be lifted. -
Page 11: Safety Check
Safety check Before putting into service initially or when putting back into service, it must be checked whether: All fastening screws (if existent), socket pins, flap socket and safety devices are tightened and secured. The wire ropes are winded up correctly, are lubricated and are in good condition. Functional test The functional test must be effected with the load capacity mentioned on the type plate. - Page 12 12.3 Inspection intervals on commissioning daily checks 1st service after 3 inspection, inspection, months service every 3 service every 12 months months Inspection of the equipment by a qualified person (periodic inspection) Check screw connections Check brake function check brake air gap (only for electric devices) *) check overload protection if existent clean and lubricate the wire rope check wire rope and wire rope end fastenings for damage...
- Page 13 13.5 Lubricant for food industry – Selection (as option*) KLÜBER SHELL MOBIL CASTROL Gearing FM Grease HD2 Mobilgrease FM 222 Klüberoil 4UH 1-1500 N Load chain Optimol Viscoleb 1500 Lubricant FM 100 Load hook; Pulleys FM Grease HD2 Mobilgrease FM 222 Gear rim;...