Transport And Storage; Transport; Safety Device For Transport; Storage - HADEF 238/10MV Installation, Operating And Maintenance Instruction

 The equipment is to be used exclusively for movement of goods. Under no circumstances my persons be
moved.
 Never load the devices beyond their working load limit.
 Pay attention to the accident prevention regulations (UVV).
 Should the hoist be used outside of Germany, please pay attention to the national regulations that apply.
 Supporting structures and load-attached devices used in conjunction with this equipment must provide an
adequate safety factor to handle the rated load plus the weight of the equipment. In case of doubt, consult
a structural engineer.
 If the equipment has not been used for a period of time, carry out visual checks of all main components
such as chains, load hooks etc. and replace any damaged parts with new, original spare parts before
putting the equipment back into operation!
 Do not use a hoist that is defective, pay attention to any abnormal noise it makes during operation.
 Stop working immediately in case of disturbances and remedy failures.
 Any damage and faults must be reported to a responsible supervisor immediately.
 If the unit is put into motion, any persons in the immediate vicinity must be informed by calling to them!
 Please pay attention to the regulations for load carrying devices UVV for both positive and non-positive
methods of attaching loads.
 The lifting tackle or the load must be securely attached to the hook and be seated at the bottom of the
hook.
 The safety catch of hooks must be closed.
 When charged, the housing may not be in contact somewhere.
 Motor drive is prohibited.
WARNING!
The following is not allowed:
 to lift another load than the nominal safe working load
 to manipulate the sliding clutch if units are equipped with
 The use of elongated or damaged chains or wire ropes. Replace them immediately by new, original
parts.
 Never loop the load chain around a load nor place or pull the chain over edges.
 Never repair damaged load hooks (e.g. by hammering), but replace them by original hooks.
3

Transport and Storage

CAUTION!
Transport may only be done by qualified personnel. No liability for any damage resulting from improper
transport or improper storage.
3.1

Transport

The devices are checked and if so adequately packed before delivery.
 Do not throw or drop the equipment.
 Use adequate means of transport.
Transport and means of transport must be suitable for the local conditions.
3.2

Safety device for transport

NOTICE!
Should a safety device for transport exist, please remove it before commissioning.
3.3

Storage

 Store the equipment at a clean and dry place.
 Protect the equipment against dirt, humidity and damage by an appropriate cover.
6
5.52.208.00.01.07