Table of Contents
Advertisement
3.3.35. DSDF Unit for GX model
1. Remove the rear cover.
2. Remove 1 screw. Unplug the DSDF harness from the
main board.
3. Remove the DSDF connector cover.
4. Unplug the DSDF harness from the scan joint board.
Copyright© 1995-2017 SAMSUNG. All rights reserved.
5. Open the DSDF unit. Remove 2 screws.
6. Lift up and release the DSDF unit.
NOTE
Shading Test for DSDF Unit must be carried out, after
replacing the DSDF unit. (Refer to 4.5.5.3)
3. Disassembly and Reassembly
3-65
Advertisement
Table of Contents
Troubleshooting
