Yamaha CZD250-A Owner's Manual page 92

Periodic maintenance and adjustment
6. Remove and replace the oil filter
element and O-ring.
1. Oil filter element
2. O-ring
7. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
9
Tightening torque:
Oil filter element cover bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
TIP
Make sure that the O-ring is properly
seated.
8. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
20 N·m (2.0 kgf·m, 15 lb·ft)
1
9. Refill with the specified amount of
the recommended engine oil.
Recommended engine oil:
SAE 10W-40, API service SG type
or higher, JASO standard MB.
Oil quantity:
2
Oil change:
1.50 L (1.59 US qt, 1.32 Imp.qt)
With oil filter removal:
1.60 L (1.69 US qt, 1.41 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
Make sure that no foreign material
enters the crankcase.
10. Install and tighten the oil filler cap
and its O-ring.
11. Start the engine, and then let it idle
12. Turn the engine off, wait a few
ECA24060
9-11
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
minutes for the oil level to settle for
an accurate reading, and then
check the oil level and correct it if
necessary.