Yamaha CZD250-A Owner's Manual page 59

Right
1
2
1. Stop/Run/Start switch " / /
2. Hazard switch " "
Dimmer/Pass switch " /
Set this switch to " " for the high
beam and to " " for the low beam.
To flash the high beam, push the
switch down towards "PASS" while the
headlights are on low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
"
Press this switch to sound the horn.
EAU54203
/PASS"
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to "
the switch down towards "
page 8-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
Use this switch to turn on the hazard
lights (simultaneous flashing of all turn
signal lights).
Instrument and control functions
The hazard lights are used in case of an
EAU12461
/ "
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
". When
The hazard lights can be turned on or
off only when the main switch is in the
"ON" position. You can turn the main
switch to the "OFF" or "LOCK" posi-
tion, and the hazard lights will continue
to flash. To turn off the hazard lights,
EAU12501
" turn the main switch to the "ON" posi-
tion and operate the hazard switch
again.
EAU54213
/ / "
NOTICE
Do not use the hazard lights for an
", and then push
extended length of time with the en-
". See
gine not running, otherwise the bat-
tery may discharge.
" to stop the en-
EAUN3950
6-21
6
ECA10062