Connect With Screen - Adafruit ESP32-S3 Manual

Now, plug your board. In Terminal, type:
ls /dev/tty.*
This will show you the current serial connections, which will now include your board.
A new listing has appeared called
part of this listing is the name the example board is using. Yours will be called
41441
something similar.
Using Linux, a new listing has appeared called
this listing is the name the example board is using. Yours will be called something
similar.

Connect with screen

Now that you know the name your board is using, you're ready connect to the serial
console. You're going to use a command called
included with MacOS. To connect to the serial console, use Terminal. Type the
following command, replacing
using:
screen /dev/tty.board_name 115200
The first part of this establishes using the
screen the name of the board you're trying to use. The third part tells screen what
baud rate to use for the serial connection. The baud rate is the speed in bits per
second that data is sent over the serial connection. In this case, the speed required
by the board is 115200 bits per second.
©Adafruit Industries
/dev/tty.usbmodem141441
/dev/ttyACM0
screen
with the name you found your board is
board_name
screen
. The
tty.usbmodem1
. The
ttyACM0
. The
screen
command. The second part tells
part of
command is
Page 86 of 263