Adafruit ESP32-S3 Manual page 235

Moving from WipperSnapper to CircuitPython
Follow the steps on the
board running WipperSnapper.
• If you are unable to double-tap the RST button to enter the UF2 bootloader,
follow the "Factory Resetting a WipperSnapper Board" instructions below.
Uploading this sketch will overwrite WipperSnapper. If you want to re-install
WipperSnapper, follow the instructions at the top of this page.
Moving from WipperSnapper to Arduino
If you want to use your board with Arduino, you will use the Arduino IDE to load any
sketch onto your board.
First, follow the page below to set up your Arduino IDE environment for use with your
board.
Then, follow the page below to upload the "Arduino Blink" sketch to your board.
Uploading this sketch will overwrite WipperSnapper. If you want to re-install
WipperSnapper, follow the instructions at the top of this page.
Factory Resetting a WipperSnapper Board
Sometimes, hardware gets into a state that requires it to be "restored" to the original
state it shipped in. If you'd like to get your board back to its original factory state,
follow the guide below.
©Adafruit Industries
Installing CircuitPython
Setup Arduino IDE
Upload Arduino Blink Sketch
Factory Reset
page () to install CircuitPython on your
Page 235 of 263