Table of Contents
Advertisement
GOAL of EXAMPLE:
Change BATT TYPE from 4CELL to 5CELL . Open the menu, then open PARAMETER
Model data transmission ( MDL-TRANS ): Transmission of model data is possible with T8J transmitters. Data transfer is
performed on radio.
The present model is MDL-TRANS with each transmitter. As for a receiving side, the present model data is rewritten.
*T8J does not carry out normal operation during data transfer.
GOAL of EXAMPLE:
MDL-TRANS is performed.
Where next?
STEPS:
submenu.
Go to BATT TYPE and change setting.
(Ex: 5CELL )
Close.
Always check servo direction prior to every flight as an additional
NOTE:
STEPS:
Open MDL-TRANS function.
The transmitting side is turned on.
Data is transmitted.
Data Trans is for 10 seconds.
Close.
SELECT a different model to edit or delete: p. 27.
NAME the model: p. 29.
34
INPUTS:
for 1 second.
to PARAMETER .
to BATT TYPE .
to 5CELL .
INPUTS:
for 1 second.
to MDL-TRANS .
Select TRANSFER or RECEIVE .
to Execute .
for 1 second .
T8J of a receiving side is set to RECEIVE ,
and the same procedure is followed.
T h e c o m p l e t i o n o f t r a n s m i s s i o n
→ "Complete"
Transmission failure
→ "Failure"
Advertisement
Table of Contents
