FUTABA T8J FUT01004369-3 Instruction Manual page 67

GOAL of EXAMPLE:
Set up a RUDD-ELEV curve mix on a
model that pitches down severely at
full rudder and not at all with minimal
rudder input, and pitches worse on right
rudder than left:
P-1: 25%
P-2: 8%
P-3: 0%
P-4: 10%
P-5: 28%
ON when SWITCH C is down.
(Note that point 3 is 0%. Otherwise,the
elevator would be retrimmed when the
mix is active and no rudder input is
given.)
Where next?
STEPS:
Open an unused curve programmable
mix. (Ex: use PROG.MIX6 since it is
RUDDER-ELEV .)
Activate the function.
Choose master and slave channels.
(Ex: do not change MAS or SLV ).
Assign SWITCH and position.
(Ex: change to C , DOWN .)
Optional: set switch to THR to activate
mix with THROTTLE STICK. (See
above for details.)
Optional: set switch position to NULL
THR
Set desired percent at the stick points.
(Ex: listed at left.)
Close menu.
Adjust servo END POINTs : see p. 36.
Set up AILEVATOR : see p. 54.
INPUTS:
for 1 second.
to P.MIX1-6 .
to 6 .
to MIX .
already RUDD
already ELEV
to SW .
to POSI .
to SW .
to POSI .
THROTTLE STICK to desired
point.
for 1 second to set.
to POSI .
to P-1 .
69
to ON .
to C .
to DOWN .
to THR .
to NULL .
to 25% .