Table of Contents
Advertisement
GOAL of EXAMPLE:
Activate AIRBRAKE on a FLAPERON .
model. Adjust the flaperon travel to
75% ,with negative elevator (push) of
25% .
Where next?
STEPS:
FLAPERON is active.
Open the AIRBRAKE function.
Activate the function.
SW selection.
A position is turned ON by down with a
center.
Adjust the travels as needed.
(Ex:Ailerons each 75% , Elevator -25% .)
O p t i o n a l : d e l a y h o w q u i c k l y t h e
elevator servo responds.
Optional: change the mixing from full
amount upon switch to proportional to
the THROTTLE STICK
idle.
Close menu.
Set up ELE-FLAP mixing: see p. 59.
INPUTS:
see FLAPERON instructions.
for 1 second.
to AIRBRAKE .
Switch C in up position.
to MIX .
to SW .
to DOWN .
to AIL1 .
to ELEV .
to FLAP .
to MODE .
to 0% .
THROTTLE STICK to desired
point.
for 1 sec, until beeps
(display changes if new setting is different from prior
setting).
FLAPERON ): see p. 50.
61
to OFF .
to SWC .
to CT&DN .
to 75% .
to -25% .
to 75% .
ELEV .
to 25% .
to LINR ( 0% ).
Advertisement
Table of Contents
