Checking The Brake Fluid Level - Yamaha 5KM2-AE1 Service Manual

È
É
ADJUSTING THE REAR BRAKE/

CHECKING THE BRAKE FLUID LEVEL

G
Adjust the select lever control cable.
Refer to "ADJUSTING THE SELECT LEVER
CONTROL CABLE AND SHIFT ROD".
G
Install the rear brake master cylinder cover.
WARNING
After this adjustment is performed, lift the
front and rear wheels off the ground by
placing a block under the engine, and spin
the rear wheels to ensure there is no brake
drag. If any brake drag is noticed perform
the above steps again.
*****************************************************
CHECKING THE BRAKE FLUID LEVEL
1.Place the machine on a level surface.
NOTE:
When inspecting the brake fluid level, make
sure that the top of the brake fluid reservoir top
is horizontal.
2.Remove:
Rear brake master cylinder cover 1
G
3.Check:
Brake fluid level
G
Fluid level is under "LOWER" level line 1 →
Fill up.
Recommended brake fluid:
DOT 4
È Front brake
É Rear brake
CAUTION:
Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
3 - 41
CHK
ADJ