Njoy Ranger 60KR User Manual page 9

PBAT
NBAT
NOTE 1: Make sure that the wires are connected securely with the
terminals.
NOTE 2: Please install the output breaker between the output terminal
and the load, and the breaker should have leakage current protective
function if necessary.
6) Put the terminal block cover back at the rear panel of the UPS.
WARNING
● Make sure a DC breaker or other protective device between UPS and
the external battery pack is installed for added safety. If not, please
install it carefully. Switch off the battery breaker before installation.
NOTE: Set the battery pack breaker in "OFF" position and then install
the battery pack.
● Pay special attention to the rated battery voltage marked on the rear
panel. If you want to change the numbers of the battery in a chain,
make sure you modify the UPS setting accordingly. Connection with
wrong battery voltage may cause irreversible damage of the UPS.
● Pay special attention to the polarity marking on external battery
terminal block. Connection with wrong battery voltage may cause
irreversible damage of the UPS.
TO UPS BAT+
Battery wires connection schematic
TO UPS BAT N
TO UPS BAT-
9