Njoy Ranger 60KR User Manual page 29

● 09: Maximum battery discharge time setting
Interface
Parameter 3:
000~999: Set the maximum discharge time from 0 min to 999 min. UPS
will shut down to protect battery if the discharge time arrives before the
Setting
battery is under voltage. The default value is 990 min.
DIS: Disable battery discharge protection and backup time will depend
on battery capacity.
● 10: Reserved
Interface
Setting
Reserve for future options.
● 11: Hot standby function Setting
Interface
Parameter 2:
HS.H: Indicates Hot standby function.
Parameter 3: Enable or disable hot standby function.
YES: Hot standby function is enabled. It means that the current UPS
Setting
is set to host of the hot standby function, and it will restart After AC
recovery even without battery connected.
NO: Hot standby function is disabled. The UPS is running at Normal
mode and can't restart without battery.
● 12: Neutral loss detection
Interface
Parameter 2:
N.L: Indicates neutral loss detection function.
Setting Parameter 3:
DIS: Disable the neutral loss detection function. The UPS will not detect
the neutral loss or not.
29