Battery information
Input & Battery voltage information
3.3 Audible Alarm
Description
UPS status
Bypass mode
Battery mode
Fault mode
Warning
Overload
Others
Fault
All
3.4 Single UPS Operation
1. Turn on the UPS with utility power (in AC mode)
1) After power mains is connected correctly, set the breaker of the
battery pack to "ON" position. Then set the line input breaker to "ON"
position. At the same time, the fan will start running and the UPS will start
initialization. After a few seconds, the UPS will supply power to the loads
via the Bypass mode.
14
Indicates the battery capacity by 0-25%, 26-50%,
51-75%, and 76-100%.
Indicates the battery is not connected.
Indicates low battery level and low battery voltage.
Indicates the input voltage or frequency or battery
voltage.
Vac: Input voltage, Vdc: battery voltage, Hz: input
frequency.
Buzzer status
Beeping once every 2 minutes
Beeping once every 4 seconds
Beeping continuously
Beeping twice every second
Beeping once every second
Beeping continuously
Muted
Yes
No
Yes