Adjusting The Slide Separating System - Primera SignatureEVO User Manual

3I. Adjusting the Slide Separating System
The slide separating system supplies an air burst between the bottom two slides in order to separate the slides as
they feed out of the slide cartridge. The slide separating system uses a pump and compressed air. You may
occasionally hear sounds of the compressor and the air being released.
There are three modes available in the PTLab software.
1. Engage when needed. This is the default setting. In this mode the air burst is only used when the slide is not
pulled from the cartridge on the first attempt. The system will try again while using the air burst to assist the
slide separation.
2. Engage every slide. In this mode the air burst is used on every attempt to feed a slide. This mode takes more
time and is louder than the engage as needed mode.
3. Disabled. In this mode the air burst is disabled.
To access this setting, open PTLab and click on the settings icon in the upper left – Click the Advanced Menu.
Page | 31