Retrieving A Broken Slide - Primera SignatureEVO User Manual

3G. Retrieving a Broken Slide
If a slide is broken or stuck in the system there are two access panels that can be used to retrieve the slide. If a
slide is found inside the printer, use the Power and Slide buttons to move the internal slide rollers forward and
back to advance the slide to a point where it can be removed. Follow this procedure:
1. Open the top cover.
2. Remove the Ribbon.
3. Remove the slide cartridge.
4. In the slide cartridge compartment check near the bottom roller for a slide.
5. Check under the ribbon. Use the Power and Slide buttons to move the slide to a position where you can
remove it. Tip! Once the slide is on the rubber belts near the back, you can close the cover and press the
slide button to advance the side down the slide chute.
6. If the slide is near the back and you are unable to retrieve it using the buttons you can remove the back
cover panel.
Page | 29
Screws for Access Panel