System Requirements - Primera Signature, Inscripta rinter Autoloader Operator's Manual

Rear Panel
This illustration shows the input ports found on the rear panel of Conductor:
Please note that the SCSI port is not installed on your Conductor. Instead, a metal blank-off plate
has been put in its place. The Control Port is installed but not used. Both of these ports are for a
future upgrade to a fully automatic optical disc duplication and printing system called Composer™.
An upgrade to a Composer is accomplished by adding Windows
CD-R or DVD-R drive. Contact your reseller or the factory for information on how to accomplish this
upgrade. Your printer autoloader configuration will use only the Printer Control Port and the Power
Input Port.
E. System Requirements
Before getting started, it is important for you to verify that the PC you plan to use with Conductor
meets these minimum system requirements:
Pentium II/III or Celeron™ Processor, 233 MHz or higher
®
32MB RAM
Windows 95/98/NT/2000 operating system
Free hard drive space of at least 2MB
8
Control Port
SCSI Port
Figure 3: Rear Panel of Conductor
Power Input Port
Printer Control Port
-based duplication software and a
®