Table of Contents
Advertisement
7.5
Defrosting
If the FG10I DGT, FG10I DGT CHILL&CW refrigerator is left to operate for very long periods of
time, it is possible for ice to form on its inside walls.
If the ice becomes considerably thick, it is advisable to defrost the refrigerator in order to continue
EN
to guarantee good appliance efficiency and avoid higher electricity consumption.
To defrost the appliance, switch it off, holding the button
of the thermostat for at least 3
seconds; we recommend to leave the refrigerator door open to speed up this operation.
Never use tools or any type of utensils to remove ice, this could damage the evaporator, which is
in contact with the inside walls of the refrigerator. The manufacturer cannot accept any liability for
damage to the appliance caused by failure to abide by this recommendation.
NOTE: During defrosting operation, do not leave the milk container inside the refrigerator.
At the end of the defrosting operation, after cleaning and thoroughly drying the inside walls of the
refrigerator, switch it on holding button
of the thermostat for at least 3 seconds.
7.6
Cleaning and maintenance
Under the current regulations regarding health and safety, the operator is responsible for the
hygiene of food contact materials and must maintain and clean the unit, preventing the bacteria
formation.
Before performing any cleaning and / or maintenance operation, disconnect the electrical supply to
the refrigerator.
It's good practice use sanitizing products for cleaning surfaces not directly in contact with food. The
outside of the refrigerator (plastic coated steel) can be washed firstwith warm water and then
rinsed in cold water and dried with a soft cloth. Do not use abrasive products.
To clean the inside of the refrigerator, after removing any containers of milk or similar liquids for
human consumption, wipe with warm water and if necessary, a little vinegar to remove any grease.
Rinse with clean water and dry with a soft cloth.
Never use abrasive products, detergents or soap.
It is also advisable to make sure that the air-cooled condenser of the refrigerating unit at the back
of the appliance is clean. If it is particularly clogged with dust, this should be removed using a
vacuum cleaner.
In case of a prolonged period of disuse, we advise you to disconnect the refrigerator from the
power supply, empty it completely, clean it and leave the door slightly open to prevent the
formation of mold and/or unpleasant odours.
25
Advertisement
Table of Contents
