Fujitsu F2MC-16L Hardware Manual page 41

I Connecting (using flat cables) to the user system
CAUTION
Prohibition
If connectors that are mates of probe connectors B1 and B2 of the adapter board are mounted
in the user system, the user system can be connected to the adapter board via flat cables.
For the interface specifications of probe connector B1 and B2, see the Adapter Board Hardware
Manual.
Connect flat cables to the probe connector B1 and B2 in the user system, as shown in Figure
2.3-3 "Connecting (using flat cables) to the user system".
Figure 2.3-3 Connecting (using flat cables) to the user system
To connect a flat cable, push its connector into probe connector B1 or B2 until the eject locks on
both sides of the flat cable connector lock.
To disconnect a flat cable, pinch the eject locks on both sides of the flat cable connector until
the flat cable unlocks, and pull out the connector.
Make sure that power to the product is turned off and the power plug is
disconnected from outlets before connecting or disconnecting cables.
Doing so may result in device problems or electric shock.
Do not grasp the cable when unplugging the power plug and cable.
Always grasp the power plug or connector itself. Pulling the cable may
expose conductors or sever wires in it, possibly resulting in device
problems, fire, or electric shock.
Flat cables
PROBE CN B1
Get other manuals https://www.bkmanuals.com
2.3 Connecting the User System
Eject locks
PROBE CN B2
User system
27