Door - Enerzone DESTINATION 2.7 Installation And Operation Manual

6.4

Door

At the end of each heating season it is recommended to add a high temperature graphite paste
on the threads of the door handle. This paste wil protect the threads from rust and prevent dust
accumulation that can prevent the handle from rotating freely.
6.4.1 Adjustment
The door seal may be improved with a simple latch mechanism adjustment:
1. Remove the split pin by pulling and turning it using pliers.
2. Turn the handle one counterclockwise turn to increase pressure.
3. Reinstall the split pin with a small hammer.
Figure 8: Removing the split pin
Installation and Operation Manual - Destination 2.7 Insert
In order for the insert to burn at its best efficiency, the door must
provide a perfect seal with the firebox. Therefore, the gasket
should be inspected periodically to check for a good seal. The
tightness of the door seal can be verified by closing and latching
the door on a strip of paper. The test must be performed all
around the door. If the paper slips out easily anywhere, either
adjust the door or replace the gasket.
Figure 9: Installing the split pin
Page 25