Table of Contents
Advertisement
the insert. These stains can be cleaned with a special wood insert glass cleaner. Do not use
abrasive products to clean the glass.
The goal should be having a clear glass with no brown stains. If brown stains appear regularly
on the glass, something about the fuel or the operating procedure needs to be changed. When
brown streaks are coming from the edge of the glass, it is time to replace the gasket around the
glass. Always replace the gasket with a genuine one.
6.3.2
Replacement
The glass used is a ceramic glass, 5/32" (4 mm) thick,12 ⅝" x 24 ¼"(321 mm x 617 mm) tested
to reach temperatures up to 1400º F. If the glass breaks, it must be replaced with one having
the same specification. Tempered glass or ordinary glass will not withstand the high
temperatures of this unit.
To remove or replace the glass (D):
1.
Remove the door from its hinges and lay it on a
soft, flat surface.
2.
Remove the screws (A), the glass retainers (B),
and the metal frames (C).
3.
Remove the glass (D). If it is damaged install a
new one in place. The replacement glass must
have a gasket all around (see procedure below).
4.
Reinstall the glass, being careful to centre the
glass in the door and not to over-tightening the
retaining screw.
The two main causes of broken door glass are uneven placement in the door and over-
tightening the retaining screws.
6.3.3
Gasket
The glass gasket is flat, adhesive-backed, woven fibreglass. The gasket
must be centred on the edge of the glass.
1.
Follow the steps of the previous section to remove the glass.
2.
Remove the old gasket and clean the glass thoroughly.
3.
Peel back a section of the paper covering the adhesive and place the gasket
on a table with the adhesive side up.
4.
Stick the end of the gasket to the middle of one edge, then press the edge
of the glass down onto the gasket, taking care that it is perfectly centred
on the gasket.
5.
Peel off more of the backing and rotate the glass. The gasket must not be
stretched during installation.
6.
Cut the gasket to the required length. Pinch the gasket onto the glass in a
U-shape, all around the glass.
Page 24
Do not clean the glass when the insert is hot.
Do not abuse the glass door by striking or slamming shut.
Do not use the insert if the glass is broken.
C
D
E
Installation and Operation Manual - Destination 2.7 Insert
B
A
Advertisement
Table of Contents
