Bahco TAWM1412M Original Instructions Manual page 31

SLIM
DELETE PRESETS
Delete Presets function allows user to delete all presets at once.
1. From Configure menu, use UP/DOWN buttons to highlight DELETE PRESETS selection then
press ENTER button.
2. Delete Presets confirmation screen is displayed.
3. Use UP/DOWN buttons to select YES or NO selection.
4. Press ENTER button to accept selection and exit to Configure menu.
STD
Note: If Delete Presets is selected without a Preset configured, following screen is displayed:
STD
JOB MODE
Job Mode function allows user to enable or disable wrench preset Job mode. When in Job mode,
wrench executes presets in order configured and automatically switches to next preset when batch
count reaches zero. When in Job mode wrench is locked and Preset lock icon is displayed.
Note: Password entry is required to enable Job Mode. When enabled, password entry is re-
quired to re-enter Configure menu (Refer to Calibration Manual for Configure password).
1. From Configure menu, use UP/DOWN buttons to highlight JOB MODE selection then press ENTER button.
2. Job Mode enable/disable screen is displayed.
3. Use UP/DOWN buttons to select ENABLE or DISABLE.
4. Press ENTER button to accept selection and exit to Configure menu.
SLIM
SLIM
31