Advertisement
Quick Links
Advertisement
Related Manuals for Bahco WPTC Series
Summary of Contents for Bahco WPTC Series
- Page 1 WPTC Original Instructions...
-
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS WARNING. • Wear safety goggles, user RISK OF FLYING and bystanders. PARTICLES. • Be sure all components, Over-torquing can cause including all adaptors, breakage. Force against flex extensions, drivers and stops on flex head can cause sockets are rated to match head breakage. - Page 4 State’s exceeded. language. • Do not force head of flex head drives against stops. Contact BAHCO if a • Always adjust your stance translation is needed. to prevent a possible fall should something give while using tool.
- Page 5 +/-4% of the preset value from 20% to 100% of rated capacity. Interchangeable Heads Any Bahco interchangeable head may be used with the wrench. Note: It is imperative that the head used to preset the torque wrench have the same common centerline length as the head that will be used in assembly.
- Page 6 WPTC Insert the Torque Adjustment Key fully into the rear of the wrench so the hex engages the adjustment nut. Do not engage the Lock Key. Rotate the Torque Adjustment Key slightly clockwise to disengage the adjustment nut from the lock nut. Slide the Lock Key in until it engages the lock nut.
- Page 7 (PM) channels. most reliable communication Frequency Map of 802.15.4 vs. 802.11b/g between the Bahco PM and the tool in a Center Frequency (GHz) 802.11b/g LAN environment, it is usually best to choose a channel for the controller Channel 802.15.4 802.11b/g...
- Page 8 WPTC Establishing RF Communication With Bahco Process Monitors The transceiver in the PM and the one in the torque wrench each have identification numbers. When communication between the two is first established, the numbers are exchanged and stored in memory. The PM and tool will thereafter ignore communications from other radios until the number stored in memory is replaced with a different identification number.
- Page 9 Use a pen head or small screwdriver to depress the battery cover security spring and slide the battery cover plate off. Remove the old battery and recharge it. Reinstall the battery and battery cover. Note: We strongly urge that NiMH rechargeable AAA batteries are the only battery used in these products.
-
Page 10: Instruction To The User
Presetting, Calibration and Repair Presetting from our Internal After Sales Centers is available. Contact your Bahco distributor for details. Parts and factory repair are also available. - Page 11 2018/11/5 (ENG) EC DECLARATION OF CONFORMITY (DEN) EF-VERENSSTEMMELSESERKLÆRING (FRA) DÉCLARATION DE CONFORMITÉ CE (NOR) ECSAMSVERKLARING (ESP) DECLARACIÓN DE CONFORMIDAD DE LA CE (FIN) EY-VAATIMUSTENMUKAISUUSVAKUUTUS (POR) DECLARAÇÃO DE CONFORMIDADE EC (RUS) Декларация о соответствии EC (ITA) DICHIARAZIONE DI CONFORMITA’ CE (TUR) CE STANDARDİZASYON BEYANI (GER) EG-KONFORMITÄTSERKLÄRUNG (CZE) PROHLÁŠENÍ...