Bahco TAWM1412M Original Instructions Manual page 28

TAWM SERIES
Note: UNITS button can be used to select torque units while on Torque THEN Angle screen.
Note: Torque cycle is not recorded in memory unless both torque and angle reach targets.
Note: Red progress lights turn on if torque exceeds 110% of wrench full scale or if angle exceeds
target + plus tolerance while in manual mode.
Note: Torque THEN Angle Presets are entered by pressing and holding Units button while on
Torque THEN Angle screen. MAXIMUM TORQUE defaults to full range plus 10%. Refer to "Adding
a Torque Preset" and "Adding an Angle Preset" in Basic section for parameter entry.
ENABLE/DISABLE TORQUE AND ANGLE MODE
This function will allow user to enable or disable Torque AND Mode.
1. From Mode Setup menu, use UP/DOWN buttons to highlight AND DISABLED (factory default)
selection then press ENTER button.
2. TQ AND ANGLE enable/disable screen is displayed.
3. Use UP/DOWN buttons to select ENABLE or DISABLE selection.
4. Press ENTER button to accept selection and exit to Mode Setup menu.
STD
SLIM
Note: Menu selection indicates current configuration (ENABLED or DISABLED).
TORQUE AND ANGLE MODE
Torque AND Angle mode is setup by first setting a target torque and units then a target angle before selecting
Torque AND Angle mode. In Torque AND Angle mode, torque and angle are measured simultaneously.
Yellow progress lights track torque measurement. When both torque and angle reach their targets, green
progress lights turn on and torque and angle data record is stored. If either of measurements exceed their
upper tolerance, red progress lights turn on.