E4402BU Option H3B
Performance Tests and Adjustments
The tests outlined in this section are to verify the operation of the Option H3B and should
be used in conjunction with the standard ESA manuals.
Refer to the E4402B User's and Service Guide for operation, specifications and
performance verification.
Failure to terminate the output connector with a 50 Ω load may degrade the
NOTE
frequency response of the E4402B.
Safety and Regulatory Information
Introduction
Review this product and related documentation to familiarize yourself with safety
markings and instructions before you operate the instrument. The documentation contains
information and warnings that must be followed by the user to ensure safe operation and
to maintain the product in a safe condition.
Before Applying Power
Verify that the product is configured to match the available main power source. If this
product is to be powered by autotransformer, make sure the common terminal is connected
to the neutral (grounded) side of the ac power supply.
Connector Care and Cleaning
If alcohol is used to clean the connectors, the power cord to the instrument must be
removed. All cleaning should take place in a well ventilated area. Allow adequate time for
the fumes to disperse and moist alcohol to evaporate prior to energizing the instrument.
To prevent electrical shock, disconnect the Agilent Technologies
WARNING
model product from mains before cleaning. Use a dry cloth or one
slightly dampened with water to clean the external case parts. Do
not attempt to clean internally.
Declaration of Conformity
For a copy of the manufacturer's Declaration of Conformity for this apparatus, contact your
local Agilent Technologies office or sales representative. Refer to
and Service Offices" on page
12
17.
Performance Tests and Adjustments
"Contacting Agilent Sales
Installation Guide