KYMCO X-Town 250 ABS Service Manual page 125

10. A.C. GENERATOR/STARTER CLUTCH
Remove the reduction gear and shaft.
Inspect the reduction gear and shaft for wear
or damage.
INSPECTION
Check the operation of the sprag clutch by
turning the driven gear.
You should be able to turn the driven gear
clockwise smoothly, but the gear should not
turn counterclockwise.
Remove the starter driven gear by turning the
driven gear.
Check the starter driven gear teeth for wear or
damage.
Measure the starter driven gear boss O.D..
Service limit: 41.56 mm (1.66 in)
Measure the starter driven gear bushing I.D..
Service limit: 22.1 mm (0.884 in)
10-5
Starter Idle Gear
Reduction Gear
Driven gear
X-Town250/300 ABS
Shaft
Flywheel