Operational Modes - ADJ ENCORE LP12Z IP User Manual

O P E R A T I O N M O D E S
This device features 4 different operation modes, plus a primary/secondary setting, all of which can
be selected from the main system menu. These are easily configured and operated from the display
screen and its control buttons. Follow the directions below to set up and operate each mode.
STATIC COLOR MODE: The unit will display a single pre-programmed color macro.
1. From the main menu, press UP and DOWN to navigate to "Manual Control", then press ENTER to
select.
2. Use the UP and DOWN buttons to scroll to the "Clr Macro" option, then press ENTER.
3. Use the UP and DOWN buttons to set "Clr Macro" to the desired value. Refer to the Color Mac-
ros Chart section of this manual for information about which colors are represented by each
value. Press ENTER to confirm.
RGBL DIMMER MODE: The unit will display a single, custom mixed static color.
1. From the main system menu, press UP and DOWN to navigate to "Manual Control", then press
ENTER.
2. Use the UP and DOWN buttons to scroll through the following menu options: Red, Green, Blue,
and Lime. Press ENTER to select the desired option.
3. Use the UP and DOWN button to select the desired value for the selected option, then press EN-
TER to confirm. Selectable values range from 000 to 255.
4. Press MODE to turn to the "Manual Control" menu, and repeat steps 2 and 3 for each color option.
The unit should now steadily display the color mix that you have created.
5. Press MODE to return to the "Manual Control" menu, then use the UP and DOWN to scroll to the
"Mastr Dim" option, and press ENTER to select.
6. Use the UP and DOWN buttons to set the dimmer, then press ENTER to confirm. Selectable val-
ues range from 000 to 255.
PROGRAM MODE: The unit will run a pre-configured program that is selected by the user. Speed
and fade are adjustable.
1. From the main system menu, press UP and DOWN to navigate to "Int Progs", then press ENTER.
2. Use the UP and DOWN buttons to scroll through the program options, from Program 0 through
Program 7. The unit will preview the program shown on the display screen. Press ENTER to se-
lect the desired program.
3. Use the UP and DOWN button to scroll to "Speed" and press ENTER to select this option. Use the
UP and DOWN buttons to set the speed at which the unit will cycle through the steps of the se-
lected program. 0 is the slowest, and 255 is the fastest. Press ENTER to confirm.
4. Use the UP and DOWN button to scroll to "Fade" and press ENTER to confirm. Use the UP and
DOWN buttons to set how gradually you want the unit each step of the selected program to fade
in and out. 0 has no fade at all, 1 has a least fade, and 255 has the most. Press ENTER to con-
firm.
23