Table of Contents
Advertisement
Bellfi res
2.1.3 Fitting into an existing opening equal to or smaller than the appliance
If the opening in the fi replace is too small for the appliance, it must be enlarged by a
recognised installer in accordance with applicable building regulations.
"Lined" installation:
Please follow the installation chronology below when positioning a fi replace:
1
Positioning of the appliance / Gas supply / Electrical connection:
Place the appliance in the open fi re place and position it by the wall. Install the
appliance using a level. Ensure the gas supply pipe has already been fed through
the designated opening at the rear (tunnel), bottom or on the side. A gas tap must
be installed in the vicinity of the appliance that must remain accessible at all times.
The Netherlands: placement of the appliance's gas tap is permitted in the meter
cupboard.
U.K./Ireland: the appliance is factory equipped with a gas tap.
If the appliance is equipped with an electrical connection (applicable if the
appliance has ambient lighting and/or AC Power adaptor), this can now be
connected to a wall socket. Ensure that during installation there is no power supply
to the wall socket. The wall socket must remain accessible at all times.
2
Dismantling the door and glass: (see pictures 2.1.2)
Dismantle the door (including the glass) by loosening left- and right under a screw
a few turns. Carefully raise the door slightly, tilt forwards and take out. Remember
to wear work gloves!
3
Removing the grate:
Remove the grate around the burner by raising it and taking it out.
Installation instructions
English
25
Advertisement
Table of Contents
