Table of Contents
Advertisement
Bellfi res
1
INTRODUCTION
1.1 GENERAL
The gas fi re must be positioned and connected as an "open" appliance by a "Gas Safe
Register" registered gas installation engineer in accordance with the following installation
instructions, nationally and locally applicable regulations (see "Technical Details /
Regulations" at the rear of this manual). If you have any queries regarding the
installation, please consult your local gas company.
This manual contains directions for both positioning and for connecting the appliance.
It also contains indications for the annual maintenance, technical data for the appliance,
parts information and directions in the event of problems.
Study the Installation instructions carefully before using the appliance. We recommend
you keep this manual in a safe place for reference purposes.
Read the "Instructions for use & maintenance manual" before operating the appliance
Important:
Before beginning the installation, check that the details on the
rating plate correspond to the gas type and pressure to which
the appliance will be connected.
If an existing chimney is to be used, please consult your installer fi rst. If the chimney
was previously used for a wood or coal fi re, then it should be cleaned by an expert. A
chimney draw of approximately 5 Pa (=0,05 mbar) is suffi cient for full load of the
appliance. If the chimney draw is more than 20 Pa (=0,2 mbar), then it is recommended
to reduce it.
The appliance is factory set to the correct nominal heat input. The pilot light is set to the
correct level of consumption.
The gas fi re can be installed as an insert into an existing open fi re place or as a
built-in appliance in a new fi re place.
1.2 SAFETY
• Do not place embers, wood logs or shingles against the pilot light burner. Make sure
that the pilot fl ame can burn at all times freely over the main burner. Only in this way
is proper ignition of the main burner ensured.
Ignoring these directions could lead to a dangerous situation.
• Do not place fl ammable objects within 100 cm of the appliance. Pay special attention
to furnishings and ornaments around the fi re.
• When igniting the pilot light and burner, always keep a minimum distance of 100 cm
from the front of the appliance.
Installation instructions
English
7
Advertisement
Table of Contents
